|
|
Thread: Rotary in a 91 B22 some direction...
[' This thread is 2 pages long:
1 (2) '] |
Mazdarx605
Redlining
Posts: 314
|
posted December 09, 2003 01:29 PM |
|
Well Marty you will probably get the same answer from many of the others on this forum. We are all rotary lover here so there for we will allways say GO ROTARY!!!!!.
Anything is possible as far as swaps go but it all comes down to how much money do you have to spend? I would probably just try rotary power first,and then if it is too slow then go turbo.The thing is you will be spending a fair amount of money either way if you are to do it right.I guess I have a question for you.Will you be able/willing to perform most if not all of the work yourself?If so you will save money ,but it will still be pricey.
Every RX-7,for that matter any RX series so far has been rotary. Early rotaries may not have been as reliable.Depends on who you talk to about that.But then again the older ones were simpler,and would most likely be cheaper to get used.
I would think the older ones may be easier to swap due to the way the engine mounts,but then again most pieces from a rotary are interchangable from year-to-year engine size-to-engine size.
If you are in it to go cheap maybe a V6/8 would be easier and a bit more cost effective due to the shear numbers of those engines available.Good luck
Chris
P.S. just go out and buy a good REPU you will thank yourself in the long run.
|
|
brad
Rotorhead
Posts: 1672
|
|
posted December 09, 2003 02:41 PM |
|
does anyone know
If a Mazda B2200 has a Limited Slip Differential?
____________
-brad-
74 REPU Lawn Green
81 Rx-7 racecar. 12a J-
Bridge
|
|
Draggin_2600i
Redlining
Posts: 235
|
|
posted December 26, 2003 08:29 PM |
|
|
Accordint to Judge Ito at nopistons.com, who built the black T2 truck on page one, a first gen RX7 LSD will bolt up the the truck differential housing...
|
|
scalliwag
Revvin Up
Posts: 69
|
|
posted December 28, 2003 11:03 AM |
|
quote:
Accordint to Judge Ito at nopistons.com, who built the black T2 truck on page one, a first gen RX7 LSD will bolt up the the truck differential housing...
Wow I have to look into that! It would should be nice.
|
|
euro
Newbie
Posts: 1
|
|
posted October 06, 2006 02:34 PM |
|
swap info?
i was wondering do you need to strengthen the front suspension on a 89 b2200 if you swap in a 13b , and if there are any other parts need to be changed on the front end
|
|
| All times are PST (US)
[' This thread is 2 pages long:
1 (2) '] |
|
|
